2023 Updated Verified HPE6-A73 Downloadable Printable Exam Dumps
The Ultimate HP HPE6-A73 Dumps PDF Review
NEW QUESTION # 12
An administrator is concerned about the security of the control plane connection between an AOS-CX switch and an ArubaMobility Controller (MC) when implementing user-based tunneling How should the administrator protect this traffic?
- A. IPSec with a digital certificate
- B. IPSec with a pre-shared key
- C. PAPI with an MD5 pre-shared key
- D. GRE with a pre-shared Key
Answer: C
NEW QUESTION # 13
An administrator is defining a VSX LAG on a pair of AOS-CX switches that are defined as primary and secondary. The VSX LAG fails to establish successfully with a remote switch; however, after verification, the remote switch is configured correctly. The administrator narrows down the problem to the configuration on the AOS-CX switches.
What would cause this problem?
- A. The VSX LAG hash does not match the remote peer
- B. LACP was enabled in active mode on the VSX LAG
- C. Local optimization was not enabled on the VSX LAG
- D. The VSX LAG interfaces are in layer-3 mode
Answer: A
NEW QUESTION # 14
A company has implemented 802.1X authentication on AOS-CX access switches, where two ClearPass servers are used to implement AAA.
Each switch has the two servers defined. A network engineer notices the following command configured on the AOS-CX switches:
radius-server tracking user-name monitor password plaintext aruba123
What is the purpose of this configuration?
- A. Implement replay protection for AAA messages
- B. Define the account to implement change of authorization
- C. Define the account to implement downloadable user roles
- D. Speed up the AAA authentication process
Answer: B
Explanation:
https://techhub.hpe.com/eginfolib/networking/docs/switches/K-KA-KB/16-01/5200-
0122_access_security_guide/content/ch09s02.html
NEW QUESTION # 15
A network administrator is implementing OSPF, where there are two exit points. Each exit point has a stateful, application inspection firewall to implement company policies.
What would the best practice be to ensure that one firewall will see both directions of the traffic, preventing asynchronous connections in the network?
- A. Both ASBRs should define External Type 2 routes for the
- B. Both ASBRs should define External Type 1 routes for the
- C. Both ASBRs should define External Type 2 routes for the
- D. Both ASBRs should define External Type 1 routes for the
Answer: D
NEW QUESTION # 16
An administrator has configured the following on an AOS-CX switch:
What is the correct ACL rule configuration that would allow traffic from anywhere to reach the web ports on the two specified servers?
- A. access-list ip server 10 permit tcp any web-servers group web-ports
- B. access-list ip server 10 permit tcp any object-group web-servers object-group web-ports
- C. access-list ip server 10 permit tcp any web-servers web-ports
- D. access-list ip server 10 permit tcp any group web-servers group web-ports
Answer: C
NEW QUESTION # 17
A network administrator needs to replace an antiquated access layer solution with a modular solution involving AOS-CX switches The administrator wants to leverage virtual switching technologies. The solution needs to support high-availability with dual-control planes Which solution should the administrator implement?
- A. AOS-CX 8325
- B. AOS-CX S400
- C. AOS-CX 6300
- D. AOS-CX 6400
Answer: D
NEW QUESTION # 18
An administrator is implementing a downloadable user role solution involving AOS-CX switches. The AAA solution and the AOS-CX switches can successfully authenticate users; however, the role information fails to download to the switches. What policy should be added to an intermediate firewall to allow the downloadable role function to succeed?
- A. Allow TCP 443
- B. Allow TCP 22
- C. Allow UDP 1811
- D. Allow UDP 8211
Answer: D
NEW QUESTION # 19
What would prevent two OSPF routers from forming an adjacency? (Select two.)
- A. Different area types
- B. Different router IDs
- C. Different priorities
- D. Different MTU sizes
- E. Different IP addresses
Answer: A,D
NEW QUESTION # 20
A network administrator is tasked to set up BGP in the company's network. The administrator is defining an eBGP peering between an AOS-CX switch and a directly-connected service provider. The administrator has configured the following on the AOS-CX switch:
However, when using the "show bgp all summary" command, the state does not display "Established" for the eBGP peer. What must the administrator configure to fix this issue?
- A. router bgp 64500 neighbor 192.168.1.1 ebgp-multihop
- B. router bgp 64500 address-family ipv4 unicast neighbor 192.168.1.1 activate
- C. router bgp 64500 neighbor 192.168.1.1 update-source loopback0
- D. router bgp 64500 enable
Answer: B
NEW QUESTION # 21
A company has just purchased AOS-CX switches The company has a free and open-source AAA solution The company wants to implement access control on the Ethernet ports of the AOS-CX switches.
Which security features can the company implement given the equipment that they are using?
- A. Port-based tunneling
- B. Device fingerprinting
- C. Local user roles
- D. Downloadable user roles
Answer: C
NEW QUESTION # 22
What is correct regarding the tunneling of user traffic between AOS-CX switches and Aruba Mobility Controllers (MCs)?
- A. Uses the same management protocol as Aruba APs
- B. Supports only port-based tunneling
- C. Uses iPSec to protect the management and data traffic
- D. Uses IPSec to protect the management traffic
Answer: A
NEW QUESTION # 23
Examine the configuration performed on newly deployed AOS-CX switches:
After performing this configuration, the administrator notices that the switch ports always remain in the EAP start state. What should the administrator do to fix this problem?
- A. Define the server group cppm
- B. Set the ports to client-mode
- C. Enable change of authorization (CoA)
- D. Create and assign a local user role to the ports
Answer: A
Explanation:
https://community.arubanetworks.com/blogs/esupport1/2020/04/29/downloadable-user-role-configuration-in-aruba-os-cx-with-mac-authentication
NEW QUESTION # 24
Examine the partial output of the BGP routing table of an AOS-CX switch:
The switch is learning about four possible path to reach the 1.0.0.0/8 network. Based on this output, which next-hop route will the AOS-CX select to be placed in the IP routing table?
- A. 192.168.1.5
- B. 192.168.3.5
- C. 192 1684 5
- D. 192.168.2.5
Answer: B
NEW QUESTION # 25
Examine the network exhibit.
A company has a guest implementation for wireless and wired access. Wireless access is implemented through a third-party vendor. The company is concerned about wired guest traffic traversing the same network as the employee traffic. The network administrator has established a GRE tunnel between AOS-CX switches where guests are connected to a routing switch in the DMZ.
Which feature should the administrator implement to ensure that the guest traffic is tunneled to the DMZ while the employee traffic is forwarded using OSPF?
- A. Classifier policies
- B. Policy-based routing (PBR)
- C. User-based tunneling (UBT)
- D. OSPF route maps using the "set metric" command
Answer: C
NEW QUESTION # 26
What is correct regarding rate limiting and egress queue shaping on AOS-CX switches?
- A. Rate limiting and egress queue shaping can be applied globally
- B. Rate limiting and egress queue shaping can be used to restrict inbound traffic
- C. Limits can be defined only for broadcast and multicast traffic
- D. Traffic rate limit is configured on queue level
Answer: D
NEW QUESTION # 27
An AOS-CX switch is configured to implement downloadable user roles. Examine the AOS-CX switch output:
Based on this output, what is the state of the user's access?
- A. The RADIUS request timed out to the AAA server
- B. MAC authentication has passed, but 802.1X authentication is in progress
- C. No downloadable user role exists
- D. The port should be configured for 802.1X
Answer: D
NEW QUESTION # 28
Examine the network topology.
Company XYZ has two connections to a service provider (ISP1). Here is the configuration of Router1:
Here is the configuration of Router2:
Based on configuration of Router1 and Router2, which BGP metric is being manipulated?
- A. Local preference
- B. Multiple exit discriminator
- C. Weight
- D. AS path length
Answer: B
NEW QUESTION # 29
Which protocols are used by NetEdit to interact with third-party devices9 {Select two )
- A. Restful API
- B. telnet
- C. SNMP
- D. CDP
- E. SSH
Answer: C,E
NEW QUESTION # 30
An administrator is replacing the current access switches with AOS-CX switches. The access layer switches must authenticate user and networking devices connecting to them. Some devices support no form of authentication, and some support 802.1X. Some ports have a VoIP phone and a PC connected to the same port, where the PC is connected to the data port of the phone and the phone's LAN port is connected to the switch.
Which statement is correct about this situation?
- A. Device fingerprinting is required for authentication
- B. 802.1X must be configured to work in fallback mode
- C. The client-limit setting for port access needs to be changed
- D. Device mode should be implemented
Answer: C
Explanation:
fallback mode if for the radius part; client limit is for multiple authent on one port (ie phone + pc) From doc :
aaa port-access authenticator <port-list> client-limit <1-32>
Used after executing aaa port-access authenticator <port-list> to convert authentication from port-based to user-based. Specifies user-based 802.1X authentication and the maximum number of 802.1X-authenticated client sessions allowed on each of the ports in <port-list>. If a port currently has no authenticated client sessions, the next authenticated client session the port accepts determines the untagged VLAN membership to which the port is assigned during the session. If another client session begins later on the same port while an earlier session is active, the later session will be on the same untagged VLAN membership as the earlier session.
NEW QUESTION # 31
Examine the output from an AOS-CX switch implementing a dynamic segmentation solution involving downloadable user roles:
The downloadable user roles are not being downloaded to the AOS-CX switch Based on the above output , what is the problem?
- A. The AOS-CX swicth does not have the ClearPass certificate involved.
- B. DNS fails to resolve the ClearPass servers FQDN.
- C. The certificate that ClearPass uses is invalid
- D. There is a date/time issue between the ClearPass server and the switch.
Answer: B
NEW QUESTION # 32
An administrator is implementing a downloadable user role solution involving AOS-CX switches. The AAA solution and theAOS-CX switches can successfully authenticate users: however the role information fails todownload to the switches. Whatpolicy should be added to an intermediate firewall to allow the downloadable role function to succeed?
- A. Allow UDP 8211
- B. Allow TCP 22
- C. Allow UDP 1811
- D. Allow TCP 443
Answer: D
NEW QUESTION # 33
......
To take the HP HPE6-A73 exam, you should have a good understanding of ArubaOS-Switches and ArubaOS-CX switches, as well as experience in configuring and managing Aruba networks. You should also be familiar with VLANs, Spanning Tree Protocol, link aggregation, and other networking concepts. Additionally, you should be comfortable working with Aruba ClearPass Policy Manager and be able to troubleshoot network issues.
Achive your Success with Latest HPE6-A73 Exam: https://www.free4torrent.com/HPE6-A73-braindumps-torrent.html
Achieve The Utmost Performance In HPE6-A73 Exam Pass Guaranteed: https://drive.google.com/open?id=12pgDTyjmA9gwEkSiVqqlElrE8x6pxMwg