Tested Material Used To NSE6_FML-6.2 Test Engine Exam Questions in here [Dec-2021]
Penetration testers simulate NSE6_FML-6.2 exam PDF
NEW QUESTION 27
Examine the configured routes shown in the exhibit; then answer the question below.
Which interface will FortiMail use to forward an email message destined for 10.1.100.252?
- A. port1
- B. port3
- C. port4
- D. port2
Answer: D
NEW QUESTION 28
Refer to the exhibit.
Which configuration change must you make to block an offending IP address temporarily?
- A. Change the authentication reputation setting status to Enable
- B. Add the offending IP address to the domain block list
- C. Add the offending IP address to the user block list
- D. Add the offending IP address to the system block list
Answer: A
Explanation:
Reference: https://help.fortinet.com/fweb/550/Content/FortiWeb/fortiweb-admin/blacklisting.htm
NEW QUESTION 29
While reviewing logs, an administrator discovers that an incoming email was processed using policy IDs
0:4:9.
Which two scenarios will generate this policy ID? (Choose two.)
- A. Email was processed using IP policy ID 4
- B. FortiMail applies the default behavior for relaying inbound email
- C. Incoming recipient policy ID 9 has the exclusive flag set
- D. FortiMail configuration is missing an access delivery rule
Answer: B,D
NEW QUESTION 30
Refer to the exhibit.
It is recommended that you configure which three access receive settings to allow outbound email from the example.com domain on FML-1? (Choose three.)
- A. The Action should be set to Relay
- B. The Enable check box should be cleared
- C. The Sender pattern should be set to *@example.com
- D. The Recipient pattern should be set to 10.29.1.45/24
- E. The Sender IP/netmask should be set to 10.29.1.45/32
Answer: A,B,E
NEW QUESTION 31
Examine the FortiMail archiving policies shown in the exhibit; then answer the question below.
Which of the following statements is true regarding this configuration? (Choose two.)
- A. Only the [email protected] account will be able to access the archived email
- B. Archived email will be saved in the journal account
- C. Email sent from [email protected] will be archived
- D. Spam email will be exempt from archiving
Answer: C,D
NEW QUESTION 32
A FortiMail administrator is investigating a sudden increase in DSNs being delivered to the protected domain for undeliverable email messages. After searching the logs, the administrator identifies that the DSNs were not generated as a result of any outbound email sent from the protected domain.
Which FortiMail antispam technique can the administrator use to prevent this scenario?
- A. Bounce address tag validation
- B. Spoofed header detection
- C. Spam outbreak protection
- D. FortiGuard IP Reputation
Answer: C
Explanation:
Explanation/Reference: https://docs.fortinet.com/document/fortimail/6.2.0/administration-guide/769204/managing-the- mail-queue
NEW QUESTION 33
Examine the FortiMail active-passive cluster shown in the exhibit; then answer the question below.
Which of the following parameters are recommended for the Primary FortiMail's HA interface configuration?
(Choose three.)
- A. Enable port monitor: disable
- B. Peer IP address: 172.16.32.57
- C. Virtual IP address: 172.16.32.55/24
- D. Heartbeat status: Primary
- E. Virtual IP action: Use
Answer: C,D,E
NEW QUESTION 34
Examine the FortMail mail server settings shown in the exhibit; then answer the question below.
Which of the following statements are true? (Choose two.)
- A. mx.example.com will display STARTTLS as one of the supported commands in SMTP sessions
- B. mx.example.com will enforce SMTPS on all outbound sessions
- C. mx.example.com will drop any inbound plaintext SMTP connection
- D. mx.example.com will accept SMTPS connections
Answer: A,D
NEW QUESTION 35
A FortiMail administrator is investigating a sudden increase in DSNs being delivered to the protected domain for undeliverable email messages. After searching the logs, the administrator identifies that the DSNs were not generated as a result of any outbound email sent from the protected domain.
Which FortiMail antispam technique can the administrator use to prevent this scenario?
- A. Bounce address tag validation
- B. Spoofed header detection
- C. Spam outbreak protection
- D. FortiGuard IP Reputation
Answer: C
Explanation:
Reference:
https://docs.fortinet.com/document/fortimail/6.2.0/administration-guide/769204/managing-the-mail- queue
NEW QUESTION 36
What IP address should the DNS MX record for this deployment resolve to?
- A. 172.16.32.55
- B. 172.16.32.57
- C. 172.16.32.1
- D. 172.16.32.56
Answer: A
NEW QUESTION 37
Refer to the exhibit.
An administrator must enforce authentication on FML-1 for all outbound email from the example.com domain.
Which two settings should be used to configure the access receive rule? (Choose two.)
- A. The Recipient pattern should be set to *@example.com
- B. The Authentication status should be set to Authenticated
- C. The Action should be set to Reject
- D. The Sender IP/netmask should be set to 10.29.1.0/24
Answer: B,D
Explanation:
Explanation/Reference:
NEW QUESTION 38
Refer to the exhibit.
Which configuration change must you make to block an offending IP address temporarily?
- A. Change the authentication reputation setting status to Enable
- B. Add the offending IP address to the domain block list
- C. Add the offending IP address to the user block list
- D. Add the offending IP address to the system block list
Answer: A
Explanation:
Explanation/Reference: https://help.fortinet.com/fweb/550/Content/FortiWeb/fortiweb-admin/blacklisting.htm
NEW QUESTION 39
FortiMail is configured with the protected domain example.com.
Which two envelope addresses will require an access receive rule, to relay for unauthenticated senders?
(Choose two.)
- A. MAIL FROM: [email protected] RCPT TO: [email protected]
- B. MAIL FROM: [email protected] RCPT TO: [email protected]
- C. MAIL FROM: [email protected] RCPT TO: [email protected]
- D. MAIL FROM: [email protected] RCPT TO: [email protected]
Answer: A,C
NEW QUESTION 40
Examine the FortiMail session profile and protected domain configuration shown in the exhibit; then answer the question below.
Which size limit will FortiMail apply to outbound email?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION 41
Refer to the exhibit.
Which statement describes the impact of setting the User inactivity expiry time option to 90 days?
- A. Registered IBE users have 90 days from the time they receive a notification email message to access their IBE email
- B. First time IBE users must register to access their email within 90 days of receiving the notification email message
- C. IBE user accounts will expire after 90 days of inactivity, and must register again to access new IBE email message
- D. After initial registration, IBE users can access the secure portal without authenticating again for 90 days
Answer: C
Explanation:
Reference: https://docs.fortinet.com/document/fortimail/6.4.0/cli-reference/813529/system-encryption- ibe#config_3733402351_2450215
NEW QUESTION 42
Which three statements about SMTPS and SMTP over TLS are true? (Choose three.)
- A. SMTPS encrypts only the body of the email message
- B. SMTP over TLS connections are entirely encrypted and initiated on port 465
- C. SMTPS connections are initiated on port 465
- D. SMTPS encrypts the identities of both the sender and receiver
- E. The STARTTLS command is used to initiate SMTP over TLS
Answer: C,D,E
Explanation:
Reference:
https://docs.fortinet.com/document/fortimail/6.2.0/administration-guide/807960/fortimail-support-of- tls-ssl
NEW QUESTION 43
Refer to the exhibit.
It is recommended that you configure which three access receive settings to allow outbound email from the example.comdomain on FML-1? (Choose three.)
- A. The Action should be set to Relay
- B. The Enable check box should be cleared
- C. The Sender pattern should be set to *@example.com
- D. The Recipient pattern should be set to 10.29.1.45/24
- E. The Sender IP/netmask should be set to 10.29.1.45/32
Answer: A,B,E
NEW QUESTION 44
Refer to the exhibit.
An administrator must enforce authentication on FML-1 for all outbound email from the example.com domain. Which two settings should be used to configure the access receive rule? (Choose two.)
- A. The Recipient pattern should be set to *@example.com
- B. The Authentication status should be set to Authenticated
- C. The Action should be set to Reject
- D. The Sender IP/netmask should be set to 10.29.1.0/24
Answer: B,D
NEW QUESTION 45
Examine the access receive rule shown in the exhibit; then answer the question below.
Which of the following statements are true? (Choose two.)
- A. Email from any host in the 10.0.1.0/24 subnet can match this rule
- B. Email must originate from an example.com email address to match this rule
- C. Senders must be authenticated to match this rule
- D. Email matching this rule will be relayed
Answer: B,D
NEW QUESTION 46
......
Authentic Best resources for NSE6_FML-6.2 Online Practice Exam: https://www.free4torrent.com/NSE6_FML-6.2-braindumps-torrent.html
Get the superior quality NSE6_FML-6.2 Dumps with explanations waiting just for you, get it now: https://drive.google.com/open?id=1zE65W7cJGxygKf8fOYb2LgkyaRB8PH6o