Juniper JN0-363 Real 2023 Braindumps Mock Exam Dumps
JN0-363 Exam Questions | Real JN0-363 Practice Dumps
To be eligible for the JNCIS-SP certification, candidates must have a basic understanding of networking and the OSI model, as well as a working knowledge of Junos OS. They should also have experience working with service provider routing and switching technologies and be familiar with protocols such as BGP, OSPF, and IS-IS.
NEW QUESTION # 117
Router B is an OSPF router connected to both Area 0 and Area 2. Area 2 has been configured as a totally stubby area.Which three LSA types does Router B suppress from Area 2? (Choose Three.)
- A. Summary LSA
- B. Network LSA
- C. ASBR Summary LSA
- D. External LSA
- E. Router LSA
Answer: A,C,D
NEW QUESTION # 118
Click the Exhibit.
Referring to the exhibit, which route(s) will be exported to neighbor 192.168.1.2?
- A. 100.0.20.1/32, 192.168.1.1/32, and 100.0.0.1/32
- B. 100.0.1/32 and 100.0.20.1/32
- C. 100.0.20.1/32
- D. 10.0.0.0/24, 11.0.0.0/24,100.0.0.1/32, 100.0.20.1/32, and 192.168.1.1/32
Answer: D
NEW QUESTION # 119
You have been asked to provision a service provider's network to accommodate Layer 3 VPNs as defined in RFC 4364.Which three tasks must be performed before the provider network is ready to carry VPN traffic? (Choose three.)
- A. All Juniper Networks PE routers must be configured with a routing-instance of type vrf.
- B. All Juniper Networks PE routers must be configured with an appropriate route-target unique to the VPN.
- C. All Juniper Networks PE routers must be configured with a routing-instance containing the CE- facing interface.
- D. All Juniper Networks PE routers must be configured with an appropriate router-ID unique to the VPN.
- E. All Juniper Networks PE routers must be configured with a routing-instance of type forwarding.
Answer: A,B,C
NEW QUESTION # 120
Which IPv6 extension header notifies intermediary devices that they must inspect the packet's options?
- A. fragment header
- B. routing header
- C. destination options header
- D. hop-by-hop options header
Answer: B
Explanation:
https://en.wikipedia.org/wiki/IPv6_packet
NEW QUESTION # 121
In your RSVP network you have configured three separate LSPs to the same egress address. You have made no other configuration changes to the forwarding decisions made by the router.Which commands can you use to determine which LSP is being used to forward packets?
- A. show rsvp session
- B. show route table inet.3
- C. show route table inet.4
- D. show rsvp neighbor
Answer: B
NEW QUESTION # 122
Referring to the exhibit, which firewall filter action(s) will be applied to incoming frames to ge-1/0/3?
- A. Frames will be counted by filterB only.
- B. Frames will be counted initially by filterB and then counted by filterA.
- C. Frames will be counted initially by filterA and then counted by filterB.
- D. Frames will be counted by filterA only.
Answer: C
NEW QUESTION # 123
You are deploying link aggregation groups.
- A. Member links are required to be contiguous ports.
- B. There should only be four member links per LAG.
- C. Member links can reside on different members within an MC-LAG.
- D. By default, what are two considerations in this scenario? (Choose two.)
- E. All the ports must have the same speed.
Answer: A,B
NEW QUESTION # 124
Interface ge-0/0/0.0 connects your network to your ISP. You want to advertise this interface address as an Internal route In OSPF without creating a neighbor with your ISP.
In this scenario, how is this task accomplished?
- A. Create a generated route for Interface ge-0/0/0.0.
- B. Configure a static route for Interface ge-0/0/0.0.
- C. Add ge-0/0/0.0 as a passive interface In OSPF.
- D. Remove interface ge-0/0/0.0 from OSPF.
Answer: B
NEW QUESTION # 125
Click the Exhibit button.
Referring to the exhibit, which statement is correct?
- A. R1 will not participate in the election process
- B. R3 will not participate in the election process
- C. R4 will be the designated router
- D. R2 will be the designated router
Answer: B
Explanation:
https://www.juniper.net/documentation/en_US/junos/topics/topic-map/configuring-ospf-areas.html#id-example-controlling-ospf-designated-router-election
NEW QUESTION # 126
What are three ways to configure IPv6 addresses in your network? (Choose three.)
- A. Configure your IPv6 addresses by assigning your router a prefix list.
- B. Configure your IPv6 addresses by setting up a DHCPv6 server.
- C. Configure your IPv6 addresses by configuring support for unicast-arp-negotiation.
- D. Statically configure your IPv6 addresses.
- E. Configure your IPv6 addresses using stateless auto configuration.
Answer: B,D,E
NEW QUESTION # 127
Exhibit
Referring to the exhibit, which two statements are correct? (Choose two.)
- A. The ge-0/0'1.0 Interface is configured as passive.
- B. The OSPF Interfaces are configured as point-to-point.
- C. Junos OS default OSPF hello timers and dead intervals are used on all interfaces.
- D. The R2 device is an ABR.
Answer: A,C
NEW QUESTION # 128
Which statement describes integrated routing and bridging (IRB) interfaces?
- A. An IRB interface assigns interfaces to VLANs.
- B. An IRB interface enables Layer 2 switching on the router.
- C. An IRB interface Is an IP gateway For hosts of a bridge domain.
- D. An IRB interface defines a bridge domain.
Answer: B
NEW QUESTION # 129
Exhibit
Which two statements ate correct about the actions taken as the packet traverses the service provider MPLS network from Site 1 to Site 2 as shown in the exhibit? (Choose two.)
- A. R1 will perform a lookup using the mpls.0 table.
- B. R1 will perform a lookup using the lnet.3 table.
- C. R2 will perform a lookup using the mpls.0 table.
- D. R2 will perform a lookup using the inet.3 table.
Answer: C
NEW QUESTION # 130
Click the Exhibit button.
You have applied the policy shown in the exhibit to the forwarding table on an MX Series device.
How is traffic load-balanced?
- A. per flow
- B. per packet
- C. per segment
- D. per frame
Answer: B
NEW QUESTION # 131
Which type of load balancing is shown in the exhibit?
- A. per-flow load balancing
- B. elastic load balancing
- C. per-packet load balancing
- D. network load balancing
Answer: D
NEW QUESTION # 132
What are two valid next-hop types that would be configured for a static route? (Choose two.)
- A. An igress interface name
- B. An IP address
- C. A MAC address
- D. An egress interface name
Answer: B,D
NEW QUESTION # 133
Click the Exhibit.
On an MX Series device, you must enable routing between VLANs 100,200, and the Internet ge-5/1/0, and ge-5/1/2 are bundled into interface ae3. Ge-5/1/4, and ge-5/1/5 are bundles into interface ae2. Both AE bundles trunk VLANs 100 and 200.
In this scenario, what is the correct configuration snippet for VLAN 100?
- A. interfaces {xe-2/1/0{unit 0{family inet {address 10.0.10.2/24;}}}ip-0/0/0{unit 0{family inet {address 10.0.1.2/24;}}unit 1{family inet {address 10.0.2.2/24;}}}}bridge- domains {vlan- 100{domain-type bridge;vlan-id 100;interface ge-2/2/2.100;interface ae1.100;interface ae3.100;interface ip-0/0/0.0;}}
- B. interfaces {xe-2/1/0 {unit 0 {family inet {address 10.0.10.2/24;}}}irb {unit 0{family inet {address 10.0.1.2/24:}}unit 1 {family inet {address 10.0.2.2/24;}}}}bridge- domains {vlan- 100{domain-type bridge;vlan-id 100;interface ge-2/2/2.100;interface ae1.100;interface ae3.100;}}
- C. interfaces {xe-2/1/0 {unit 0{family inet {address 10.0.10.2/24;}}}ip-0/0/0 {unit 0 {family inet {address 10.0.1.2/24;}}unit 1 {family inet {address 10.0.2.2/24;}}}} bridge-domains {vlan- 100{domain-type bridge;vlan-id 100;interface ge-2/2/2.100;interface xe-2/1/0.0;interface ae1.100;interface ae3.100interface ip-0/0/0.0;}}
- D. interfaces {xe-2/1/0 {unit 0{family inter {address 10.0.10.2/24;}}}irb {unit 0{family inet {address 10.0.1.2/24;}}unit 1 family inet {address 10.0.2.2/24;}}}}bridge- domains {vlan- 100{domain-type bridge;vlan-id 100;interface ge-2/2/2.100;interface ae1.100;interface ae3.100;routing-interface irb.0;}}
Answer: B
NEW QUESTION # 134
......
Juniper JN0-363 Certification Exam is a valuable credential for professionals who are looking to advance their careers in service provider routing and switching. Service Provider Routing and Switching, Specialist (JNCIS-SP) certification demonstrates that the candidate has a strong understanding of the technologies and equipment used in service provider networks, and is able to apply this knowledge to design and maintain these networks.
Verified JN0-363 Exam Dumps Q&As - Provide JN0-363 with Correct Answers: https://www.free4torrent.com/JN0-363-braindumps-torrent.html
Pass Your JN0-363 Dumps Free Latest Juniper Practice Tests: https://drive.google.com/open?id=18xZQ6kx4xgrrkIuA6GHoOIHOGDrI7iuo